14 May
2008
14 May
'08
9:18 a.m.
On Wed, 14 May 2008, Jens Gehrlein wrote:
Apart from that, verify that your console=
command line parameter is correct, your machine ID matches, and that you don't have a jtag debugger like bdi2000 connected when you're trying to boot.
I have the same problem on our board: I don't see the console outputs if the BDI2000 cable is connected to the target, although the BDI is in mode "reset run". Do have an idea why?
No, I don't know "why", but that's exactly why I've mentioned it above - I had the same problem here and I spent about half a day trying to figure out why it didn't boot.
Thanks Guennadi --- Guennadi Liakhovetski