For data transfer with Auto CMD12, the host will not send an Auto CMD12 to stop when the transfer fails. So this patch adds a flag to indicate the READ/WRITE command error, and makes the driver continue to send a CMD12 manually.
Signed-off-by: Yangbo Lu yangbo.lu@nxp.com --- drivers/mmc/fsl_esdhc.c | 22 ++++++++++++++++++++-- 1 file changed, 20 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c index b06dd69..744037e 100644 --- a/drivers/mmc/fsl_esdhc.c +++ b/drivers/mmc/fsl_esdhc.c @@ -96,6 +96,9 @@ struct fsl_esdhc_priv { struct udevice *dev; int non_removable; struct gpio_desc cd_gpio; +#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111 + int rw_err; +#endif };
/* Return the XFERTYP flags for a given command and data packet */ @@ -350,8 +353,12 @@ esdhc_send_cmd(struct mmc *mmc, struct mmc_cmd *cmd, struct mmc_data *data) struct fsl_esdhc *regs = priv->esdhc_regs;
#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111 - if (cmd->cmdidx == MMC_CMD_STOP_TRANSMISSION) - return 0; + if (cmd->cmdidx == MMC_CMD_STOP_TRANSMISSION) { + if (priv->rw_err) + priv->rw_err = 0; + else + return 0; + } #endif
esdhc_write32(®s->irqstat, -1); @@ -506,6 +513,13 @@ out: /* If this was CMD11, then notify that power cycle is needed */ if (cmd->cmdidx == SD_CMD_SWITCH_UHS18V) printf("CMD11 to switch to 1.8V mode failed, card requires power cycle.\n"); +#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111 + if (cmd->cmdidx == MMC_CMD_READ_SINGLE_BLOCK || + cmd->cmdidx == MMC_CMD_READ_MULTIPLE_BLOCK || + cmd->cmdidx == MMC_CMD_WRITE_SINGLE_BLOCK || + cmd->cmdidx == MMC_CMD_WRITE_MULTIPLE_BLOCK) + priv->rw_err = 1; +#endif }
esdhc_write32(®s->irqstat, -1); @@ -796,6 +810,10 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv)
priv->cfg.b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
+#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC111 + priv->rw_err = 0; +#endif + mmc = mmc_create(&priv->cfg, priv); if (mmc == NULL) return -1;