Move setup_display from board_early_init_f to board_init. Add more clock settings. Add blacklight iomux setting. Add display_info_t info for the lvds screen.
Signed-off-by: Peng Fan Peng.Fan@freescale.com Cc: Fabio Estevam fabio.estevam@freescale.com Cc: Stefano Babic sbabic@denx.de --- board/freescale/mx6qsabreauto/mx6qsabreauto.c | 87 ++++++++++++++++++++++++++- 1 file changed, 84 insertions(+), 3 deletions(-)
diff --git a/board/freescale/mx6qsabreauto/mx6qsabreauto.c b/board/freescale/mx6qsabreauto/mx6qsabreauto.c index 7c0e90a..c2e9c57 100644 --- a/board/freescale/mx6qsabreauto/mx6qsabreauto.c +++ b/board/freescale/mx6qsabreauto/mx6qsabreauto.c @@ -412,14 +412,44 @@ u32 get_board_rev(void) }
#if defined(CONFIG_VIDEO_IPUV3) +static void disable_lvds(struct display_info_t const *dev) +{ + struct iomuxc *iomux = (struct iomuxc *)IOMUXC_BASE_ADDR; + + clrbits_le32(&iomux->gpr[2], + IOMUXC_GPR2_LVDS_CH0_MODE_MASK | + IOMUXC_GPR2_LVDS_CH1_MODE_MASK); +} + static void do_enable_hdmi(struct display_info_t const *dev) { + disable_lvds(dev); imx_enable_hdmi_phy(); }
struct display_info_t const displays[] = {{ .bus = -1, .addr = 0, + .pixfmt = IPU_PIX_FMT_RGB666, + .detect = NULL, + .enable = NULL, + .mode = { + .name = "Hannstar-XGA", + .refresh = 60, + .xres = 1024, + .yres = 768, + .pixclock = 15385, + .left_margin = 220, + .right_margin = 40, + .upper_margin = 21, + .lower_margin = 7, + .hsync_len = 60, + .vsync_len = 10, + .sync = FB_SYNC_EXT, + .vmode = FB_VMODE_NONINTERLACED +} }, { + .bus = -1, + .addr = 0, .pixfmt = IPU_PIX_FMT_RGB24, .detect = detect_hdmi, .enable = do_enable_hdmi, @@ -440,18 +470,69 @@ struct display_info_t const displays[] = {{ } } }; size_t display_count = ARRAY_SIZE(displays);
+iomux_v3_cfg_t const backlight_pads[] = { + MX6_PAD_SD4_DAT1__GPIO2_IO09 | MUX_PAD_CTRL(ENET_PAD_CTRL), +}; + +static void setup_iomux_backlight(void) +{ + gpio_direction_output(IMX_GPIO_NR(2, 9), 1); + imx_iomux_v3_setup_multiple_pads(backlight_pads, + ARRAY_SIZE(backlight_pads)); +} + static void setup_display(void) { struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR; + struct iomuxc *iomux = (struct iomuxc *)IOMUXC_BASE_ADDR; int reg;
+ setup_iomux_backlight(); enable_ipu_clock(); imx_setup_hdmi();
+ /* Turn on LDB_DI0 and LDB_DI1 clocks */ + reg = readl(&mxc_ccm->CCGR3); + reg |= MXC_CCM_CCGR3_LDB_DI0_MASK | MXC_CCM_CCGR3_LDB_DI1_MASK; + writel(reg, &mxc_ccm->CCGR3); + + /* Set LDB_DI0 and LDB_DI1 clk select to 3b'011 */ + reg = readl(&mxc_ccm->cs2cdr); + reg &= ~(MXC_CCM_CS2CDR_LDB_DI0_CLK_SEL_MASK | + MXC_CCM_CS2CDR_LDB_DI1_CLK_SEL_MASK); + reg |= (3 << MXC_CCM_CS2CDR_LDB_DI0_CLK_SEL_OFFSET) | + (3 << MXC_CCM_CS2CDR_LDB_DI1_CLK_SEL_OFFSET); + writel(reg, &mxc_ccm->cs2cdr); + + reg = readl(&mxc_ccm->cscmr2); + reg |= MXC_CCM_CSCMR2_LDB_DI0_IPU_DIV | MXC_CCM_CSCMR2_LDB_DI1_IPU_DIV; + writel(reg, &mxc_ccm->cscmr2); + reg = readl(&mxc_ccm->chsccdr); reg |= (CHSCCDR_CLK_SEL_LDB_DI0 << MXC_CCM_CHSCCDR_IPU1_DI0_CLK_SEL_OFFSET); + reg |= (CHSCCDR_CLK_SEL_LDB_DI0 << + MXC_CCM_CHSCCDR_IPU1_DI1_CLK_SEL_OFFSET); writel(reg, &mxc_ccm->chsccdr); + + reg = IOMUXC_GPR2_DI1_VS_POLARITY_ACTIVE_LOW | + IOMUXC_GPR2_DI0_VS_POLARITY_ACTIVE_LOW | + IOMUXC_GPR2_BIT_MAPPING_CH1_SPWG | + IOMUXC_GPR2_DATA_WIDTH_CH1_18BIT | + IOMUXC_GPR2_BIT_MAPPING_CH0_SPWG | + IOMUXC_GPR2_DATA_WIDTH_CH0_18BIT | + IOMUXC_GPR2_LVDS_CH0_MODE_ENABLED_DI0 | + IOMUXC_GPR2_LVDS_CH1_MODE_DISABLED; + writel(reg, &iomux->gpr[2]); + + reg = readl(&iomux->gpr[3]); + reg &= ~(IOMUXC_GPR3_LVDS0_MUX_CTL_MASK | + IOMUXC_GPR3_HDMI_MUX_CTL_MASK); + reg |= (IOMUXC_GPR3_MUX_SRC_IPU1_DI0 << + IOMUXC_GPR3_LVDS0_MUX_CTL_OFFSET) | + (IOMUXC_GPR3_MUX_SRC_IPU1_DI0 << + IOMUXC_GPR3_HDMI_MUX_CTL_OFFSET); + writel(reg, &iomux->gpr[3]); } #endif /* CONFIG_VIDEO_IPUV3 */
@@ -467,9 +548,6 @@ int overwrite_console(void) int board_early_init_f(void) { setup_iomux_uart(); -#ifdef CONFIG_VIDEO_IPUV3 - setup_display(); -#endif
#ifdef CONFIG_NAND_MXS setup_gpmi_nand(); @@ -494,6 +572,9 @@ int board_init(void) gpio_direction_output(IMX_GPIO_NR(1, 15), 1); imx_iomux_v3_setup_multiple_pads(port_exp, ARRAY_SIZE(port_exp));
+#ifdef CONFIG_VIDEO_IPUV3 + setup_display(); +#endif setup_iomux_eimnor(); return 0; }