Jihua Cheng writes:
Jihua> Yuli, Thanks very much!
Jihua> Here is the sympotoms.
Jihua> Based on the PQ2FADS-VR schematic, I route parallel portC pin Jihua> PC17(Clk 15 for RX) and pin PC16(Clk16 for TX) for Jihua> FCC3. PortB PB4~PB17 are enabled for FCC3. When I use ping Jihua> command, I got "fec: tx error!" message in the console. I Jihua> found the message is from fec_send(...) at Jihua> cpu/mpc8260/ether_fcc.c. It seems CPM did not send out the Jihua> data to Phy.
This usually indicates that there is no Tx clock, probably because the PHY does not provide it.
Jihua> 1) I check BCSR3. Both FETHIEN2 and FETH2_RST are 1.
FETHIEN2=1 means that the PHY is isolated after power-up. This is not what you want. Set FETHIEN2 to zero and reset PHY by toggling FETH2_RST.
Jihua> 2) Phy Register seems OK (Reg0 = 0x2100, reg1 = 0x7809).
It's not completely OK because auto-negotiation is disabled. It's can be a result of above mentioned isolation. Check what happens after enabling the PHY, and set as necessary.
Jihua> 3) I check PortB PB4~PB17. Dedicated Pin setting seems OK.
Jihua> Where do I need to check?
Jihua> I appreciate your help!