-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
On 06/17/13 15:38, Tom Rini wrote:
On Mon, Jun 17, 2013 at 02:53:27PM +0300, Igor Grinberg wrote:
Hi Stefan,
On 06/14/13 11:55, Stefan Roese wrote:
Add SPL U-Boot support to replace x-loader on the Compulab cm_t35 board. Currently only the 256MiB SDRAM board versions are supported.
Tested by booting via MMC and NAND.
Signed-off-by: Stefan Roese sr@denx.de Cc: Tom Rini trini@ti.com Cc: Igor Grinberg grinberg@compulab.co.il
[snip]
+/*
- 1MB into the SDRAM to allow for SPL's bss at the beginning of SDRAM
- 64 bytes before this address should be set aside for u-boot.img's
- header. That is 0x800FFFC0--0x80100000 should not be used for any
- other needs.
- */
+#define CONFIG_SYS_TEXT_BASE 0x80100000
Now this is a problem. This breaks the backward compatibility with our X-Loader and we cannot just switch to 80100000...
And thinking back to when I was doing more OMAP3 conversions, there's no requirement to break compatibility with x-loader either. You just need to take care where you place things, see doc/SPL/README.omap3 for the SPL and X-Loader compatible setup.
Actually, I was thinking about adding a target in boards.cfg, but if we can make both (X-Loader and SPL) live in piece, then IMO, we should go for it.
Thanks for the pointer!
- -- Regards, Igor.