Tom,
On 22/07/23 01:06, Tom Rini wrote:
On Sat, Jul 08, 2023 at 04:15:20PM +0530, Siddharth Vadapalli wrote:
From: Suman Anna s-anna@ti.com
Enhance the AM65 CPSW NUSS driver to perform a MDIO reset using a GPIO line. Logic is also added to perform a pre and post delay around reset using the optional 'reset-delay-us' and 'reset-post-delay-us' properties. This is similar to the reset being performed in the Linux kernel. The reset is done once when the CPSW MDIO bus is being initialized.
Signed-off-by: Suman Anna s-anna@ti.com Signed-off-by: Siddharth Vadapalli s-vadapalli@ti.com
drivers/net/ti/am65-cpsw-nuss.c | 34 ++++++++++++++++++++++++++++++++- 1 file changed, 33 insertions(+), 1 deletion(-)
So this breaks building on am62x_evm_a53 because now TI_AM65_CPSW_NUSS needs to select DM_GPIO. And the next problem is that we don't enable a GPIO driver on that platform as we should I suspect make DA8XX_GPIO default y if K3.
Sorry for the delayed response. I am planning to address this issue by using: #if CONFIG_IS_ENABLED(DM_GPIO) in the driver, similar to how it is done for other ethernet drivers such as: drivers/net/mvneta.c and drivers/net/mvpp2.c.
Also, the GPIO hog and reset capabilities are only required on those boards which have the Ethernet PHY present on a daughtercard connected to the board.
I will post the v2 of this series with the above changes to fix the build issues. Please let me know if the above approach is acceptable.