The RK3588 has a new IP for SARADC compared to older SoCs of the same vendor but most of the boilerplate is shared, so rockchip-saradc.c driver is adapted instead of creating a new one.
Because the SARADC requires a vref-supply which is commonly coming from a regulator of the RK806 PMIC, support for the RK806 PMIC and regulators are also added in this patch series. Finally, RK806 PMIC is the first one to actually support SPI as communication layer between the SoC and the PMIC (but supports I2C as well according to the datasheet). This adds support for RK806 over SPI though there should be no reason for RK806 over I2C to not work.
Note that the DT now uses a different prefix for the buck and ldo node names and the RK806 is the first one to use nldo and pldo and while they both are LDOs, they have overlapping indices which makes it impossible to simply reuse the rk8xx_ldo driver and need to define new ones (though some callbacks can be reused, as is done in this patch series).
The SARADC was tested by toggling the BIOS button connected over channel 0 on RK3588 Jaguar and using the adc or button commands to watch over the value. The PMIC was tested with the pmic command for reading the CHIP_VERS registers and writing to the WDT_REG (0x73). The regulators were tested by using a modified DT for RK3588 Jaguar and playing with the regulator command to enable/disable some buck/nldo/pldo and modify their output voltage.
This has a light dependency on https://lore.kernel.org/u-boot/20240221-jaguar-v3-0-1f256a82201b@theobroma-s... because of: - remove of asm/io.h include in favor of asm/arch-rockchip/hardware.h (both should be included if applied before the dependency) - Jaguar defconfig modified in this patch series is added in the aforementioned patch series,
Signed-off-by: Quentin Schulz quentin.schulz@theobroma-systems.com --- Quentin Schulz (15): rockchip: spi: rk_spi: do not write bytes when in read-only mode regulator: rk8xx: remove unused functions regulator: rk8xx: add indirection level for some ldo callbacks power: rk8xx: add support for RK806 pmic: reword help text rockchip: adc: rockchip-saradc: use union for preparing for v2 rockchip: adc: rockchip-saradc: factor out channel_data callback rockchip: adc: rockchip-saradc: factor out start_channel callback rockchip: adc: rockchip-saradc: factor out stop callback rockchip: adc: rockchip-saradc: add support for RK3588 power: pmic: rk8xx: fix duplicate prompt rockchip: jaguar-rk3588: enable SARADC and derivatives adc: add missing depends on ADC for controller drivers button: add missing ADC dependency for BUTTON_ADC rockchip: boot_mode: fix rockchip_dnl_key_pressed requiring ADC support
William Wu (1): regulator: rk8xx: fix SWITCH enable on RK809
arch/arm/mach-rockchip/boot_mode.c | 4 + cmd/pmic.c | 4 +- configs/jaguar-rk3588_defconfig | 11 +- drivers/adc/Kconfig | 4 + drivers/adc/rockchip-saradc.c | 176 +++++++++-- drivers/button/Kconfig | 1 + drivers/power/pmic/Kconfig | 2 +- drivers/power/pmic/rk8xx.c | 85 ++++++ drivers/power/regulator/rk8xx.c | 595 ++++++++++++++++++++++++++++++++++--- drivers/spi/rk_spi.c | 20 +- include/power/rk8xx_pmic.h | 21 +- 11 files changed, 848 insertions(+), 75 deletions(-) --- base-commit: dcf1b0a056cc81dc268d449c6e689fe80ca688ae change-id: 20240212-rk3588-saradc-ab0a9bda9306
Best regards,