6 Jul
2004
6 Jul
'04
7:29 p.m.
In message ccebh8$j6f$1@sea.gmane.org you wrote:
I have an MV64360 board (IBM dev brd), that has PIBS on it. What's the best way to use u-boot with it?
Erase PIBS and install U-Boot instead ;-)
I compiled u-boot with powepc-gcc-3.3.4 (compiled via crosstool), but PIBS fails to load the binary (.bin). (In fact, PIBS doesn't recognize any of the binaries).
Then find out what PIBS expects.
So what's the recommended way? Should I put u-boot on the flash, overwriting
Yes.
PIBS? And since I don't have a BDI cable, how can I put u-boot on the board?
Get a BDI2000; the box also includes the required cable.
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de
They say, well, meybe it _is_ smelly, maybe it _is_ overcrowded, may-
be it _is_ a bit like Hell would be if they shut the fires off and
stabled a herd of incontinent cows there for a year, but you must
admit that it is full of sheer, vibrant, dynamic _life_.
- Terry Pratchett, _Moving Pictures_