From: Lukas Funke lukas.funke@weidmueller.com
On ZynqMp there seems to be a dependency between the card-stable bit and the card-detect bit. The card-stable bit is set *if and only if* the card-detect bit was set before, indicating that the signal was stable and reliable during card insertion.
If the card-detect bit is *not* evaluated the corresponding check leads to a timeout indicating that the card-detect was not stable.
Signed-off-by: Lukas Funke lukas.funke@weidmueller.com ---
drivers/mmc/zynq_sdhci.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c index 935540d171..d0bccd41cc 100644 --- a/drivers/mmc/zynq_sdhci.c +++ b/drivers/mmc/zynq_sdhci.c @@ -1168,11 +1168,14 @@ static int arasan_sdhci_probe(struct udevice *dev) */ if (IS_ENABLED(CONFIG_ARCH_ZYNQMP) || IS_ENABLED(CONFIG_ARCH_VERSAL)) { u32 timeout = 1000000; + u32 value;
- while (((sdhci_readl(host, SDHCI_PRESENT_STATE) & - SDHCI_CARD_STATE_STABLE) == 0) && timeout) { + value = sdhci_readl(host, SDHCI_PRESENT_STATE); + while ((value & SDHCI_CARD_PRESENT) && + ((value & SDHCI_CARD_STATE_STABLE) == 0) && timeout) { udelay(1); timeout--; + value = sdhci_readl(host, SDHCI_PRESENT_STATE); } if (!timeout) { dev_err(dev, "Sdhci card detect state not stable\n");