On Wednesday, May 22nd, 2024 at 9:40 PM, E Shattow lucent@gmail.com wrote:
On Wed, May 22, 2024 at 12:13?PM H Bell dmoo_dv@protonmail.com wrote:
- {"/soc/ethernet@16040000/mdio/ethernet-phy@1",
- "tx-internal-delay-ps", "300"},
Note this 300uS value for tx-internal-delay-ps differs from pre-loaded firmware on Star64: ethernet-phy@1 tx_delay_sel = <0x00>;
I would prefer to this (even if it is wrong) same as the pre-loaded firmware has done. Tuning patches can be applied in some future series. Is there a noticeable difference in function to change this value from how the pre-loaded firmware does this?
I agree that it should stick to the pre-loaded firmware wherever possible but I found that using the 0 value on the tx_delay_sel meant that the device would not properly send packets over the network (and would not get granted an IP over DHCP), and found (going in steps of 150) that 300 worked.