On 30 October 2014 15:00, Marek Vasut marex@denx.de wrote:
Add example config file entry for the Altera SPI controller. This SPI controller can also, under special conditions, be used to operate the EPCS/EPCQ SPI NOR.
Signed-off-by: Marek Vasut marex@denx.de Cc: Chin Liang See clsee@altera.com Cc: Dinh Nguyen dinguyen@opensource.altera.com Cc: Vince Bridgers vbridger@altera.com Cc: Pavel Machek pavel@denx.de Cc: Stefan Roese sr@denx.de
include/configs/socfpga_common.h | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+)
diff --git a/include/configs/socfpga_common.h b/include/configs/socfpga_common.h index 83a1bcd..1df886b 100644 --- a/include/configs/socfpga_common.h +++ b/include/configs/socfpga_common.h @@ -79,6 +79,25 @@ #define CONFIG_SYS_PL310_BASE SOCFPGA_MPUL2_ADDRESS
/*
- EPCS/EPCQx1 Serial Flash Controller
- */
+#ifdef CONFIG_ALTERA_SPI +#define CONFIG_CMD_SPI +#define CONFIG_CMD_SF +#define CONFIG_SF_DEFAULT_SPEED 30000000 +#define CONFIG_SPI_FLASH +#define CONFIG_SPI_FLASH_STMICRO +#define CONFIG_SPI_FLASH_BAR +/*
- The base address is configurable in QSys, each board must specify the
- base address based on it's particular FPGA configuration. Please note
- that the address here is incremented by 0x400 from the Base address
- selected in QSys, since the SPI registers are at offset +0x400.
- #define CONFIG_SYS_SPI_BASE 0xff240400
So each board-specific config header will define CONFIG_SYS_SPI_BASE is it? for using ALTERA_SPI
- */
+#endif
+/*
- Ethernet on SoC (EMAC)
*/
#if defined(CONFIG_CMD_NET) && !defined(CONFIG_SOCFPGA_VIRTUAL_TARGET)
2.0.0
thanks!