-----Original Message----- From: Marek Vasut [mailto:marex@denx.de] Sent: Wednesday, December 21, 2016 10:10 PM To: Peng Fan peng.fan@nxp.com; sbabic@denx.de Cc: u-boot@lists.denx.de; van.freenix@gmail.com Subject: Re: [PATCH 3/3] imx: mx6sllevk: add usb support
On 12/21/2016 09:14 AM, Peng Fan wrote:
Add usb support for mx6sllevk board.
Signed-off-by: Peng Fan peng.fan@nxp.com Cc: Stefano Babic sbabic@denx.de
[......]
+#define USB_OTHERREGS_OFFSET 0x800 +#define UCTRL_PWR_POL (1 << 9)
+int board_ehci_hcd_init(int port) +{
- u32 *usbnc_usb_ctrl;
- if (port > 1)
return -EINVAL;- usbnc_usb_ctrl = (u32 *)(USB_BASE_ADDR + USB_OTHERREGS_OFFSET
port * 4);- /* Set Power polarity */
- setbits_le32(usbnc_usb_ctrl, UCTRL_PWR_POL);
- return 0;
+}
Is this function similar to what usb_oc_config() does ?
No, this bit is not for overcurrent. According to RM, this is OTG Power Polarity This bit should be set according to power switch's enable polarity. 1 Power switch has an active-high enable input 0 Power switch has an active-low enable input
This is board specific.
Regards, Peng.
-- Best regards, Marek Vasut