Add support for handling SFP TX disable for MVNETA in the same fashion as to what MVPP2 is doing in order to enable using SFP-s.
This allows using ethernet on SFP only boards.
Signed-off-by: Robert Marko robert.marko@sartura.hr --- Changes in v2: * Parse the standard SFP node for TX disable GPIO instead of using a custom property
drivers/net/mvneta.c | 12 ++++++++++++ 1 file changed, 12 insertions(+)
diff --git a/drivers/net/mvneta.c b/drivers/net/mvneta.c index 4a4268c2b2..018f2da393 100644 --- a/drivers/net/mvneta.c +++ b/drivers/net/mvneta.c @@ -286,6 +286,7 @@ struct mvneta_port { struct phy_device *phydev; #if CONFIG_IS_ENABLED(DM_GPIO) struct gpio_desc phy_reset_gpio; + struct gpio_desc sfp_tx_disable_gpio; #endif struct mii_dev *bus; }; @@ -1693,6 +1694,9 @@ static int mvneta_probe(struct udevice *dev) { struct eth_pdata *pdata = dev_get_plat(dev); struct mvneta_port *pp = dev_get_priv(dev); +#if CONFIG_IS_ENABLED(DM_GPIO) + struct ofnode_phandle_args sfp_args; +#endif void *blob = (void *)gd->fdt_blob; int node = dev_of_offset(dev); struct mii_dev *bus; @@ -1767,6 +1771,11 @@ static int mvneta_probe(struct udevice *dev) return ret;
#if CONFIG_IS_ENABLED(DM_GPIO) + ret = dev_read_phandle_with_args(dev, "sfp", NULL, 0, 0, &sfp_args); + if (!ret) + gpio_request_by_name_nodev(sfp_args.node, "tx-disable-gpio", 0, + &pp->sfp_tx_disable_gpio, GPIOD_IS_OUT); + gpio_request_by_name(dev, "phy-reset-gpios", 0, &pp->phy_reset_gpio, GPIOD_IS_OUT);
@@ -1775,6 +1784,9 @@ static int mvneta_probe(struct udevice *dev) mdelay(10); dm_gpio_set_value(&pp->phy_reset_gpio, 0); } + + if (dm_gpio_is_valid(&pp->sfp_tx_disable_gpio)) + dm_gpio_set_value(&pp->sfp_tx_disable_gpio, 0); #endif
return board_network_enable(bus);