Hi Simon,
On 17/09/14 18:02, Simon Glass wrote:
GPIOs should be requested before use. Without this, driver model will not permit the GPIO to be used.
Signed-off-by: Simon Glass sjg@chromium.org
This patch introduces a bunch of errors (once the driver model stuff is turned on), all related to the gpios never being freed, but requested anew when reinitializing subsystems.
The errors are:
CM-FX6 # sata init Warning: iSSD setup failed! AHCI 0001.0300 32 slots 1 ports 3 Gbps 0x1 impl SATA mode flags: ncq stag pm led clo only pmp pio slum part SATA Device Info: S/N: 123900127157 Product model number: SanDisk SSD i100 8GB Firmware version: 11.56.00 Capacity: 15649200 sectors
CM-FX6 # usb start (Re)start USB... USB0: USB OTG pwr gpio request failed: -16 USB OTG pwr gpio request failed: -16 USB EHCI 1.00 scanning bus 0 for devices... 2 USB Device(s) found USB1: USB hub rst gpio request failed: -16 USB hub rst gpio request failed: -16 USB EHCI 1.00 scanning bus 1 for devices... 6 USB Device(s) found scanning usb for storage devices... max USB Storage Device reached: 5 stopping 5 Storage Device(s) found
CM-FX6 # sf probe mxc_spi: cannot setup gpio -16 SF: Failed to set up slave Failed to initialize SPI flash at 0:0
CM-FX6 # saveenv Saving Environment to SPI Flash... mxc_spi: cannot setup gpio -16 SF: Failed to set up slave *** Warning - spi_flash_probe() failed, using default environment
I am going to submit a modified version of the cm_fx6 patches to address these problems.