Hi Andrey,
On Wed, Jun 8, 2022 at 4:46 AM ZHIZHIKIN Andrey andrey.zhizhikin@leica-geosystems.com wrote:
The problem seems to be related to the TF-A version.
If I use the older imx_5.4.47_2.2.0 TF-A then the sha256 calculation via CAAM does not fail.
I just tried the imx8mp_evk and with CONFIG_IMX_HAB=y the board does not pass the SPL.
I used the upstream TF-A for my build, without HAB support enabled the board boots:
U-Boot SPL 2022.07-rc4-00003-g9eca6cc66a (Jun 08 2022 - 08:21:41 +0200) SEC0: RNG instantiated Normal Boot WDT: Started watchdog@30280000 with servicing (60s timeout) Trying to boot from BOOTROM image offset 0x8000, pagesize 0x200, ivt offset 0x0 NOTICE: BL31: v2.7(release):v2.7.0-17-g65a5e1c04-dirty NOTICE: BL31: Built : 06:19:26, Jun 8 2022
U-Boot 2022.07-rc4-00003-g9eca6cc66a (Jun 08 2022 - 08:21:41 +0200)
CPU: Freescale i.MX8MP[8] rev1.0 at 1200 MHz Reset cause: POR Model: NXP i.MX8MPlus EVK board DRAM: 6 GiB Core: 176 devices, 22 uclasses, devicetree: separate WDT: Started watchdog@30280000 with servicing (60s timeout) MMC: FSL_SDHC: 1, FSL_SDHC: 2 Loading Environment from MMC... *** Warning - bad CRC, using default environment
In: serial@30890000 Out: serial@30890000 Err: serial@30890000 SEC0: RNG instantiated Net: eth0: ethernet@30be0000, eth1: ethernet@30bf0000 [PRIME] Hit any key to stop autoboot: 0 u-boot=>
When HAB in enabled, the only thing that can be observed in the console is:
U-Boot SPL 2022.07-rc4-00003-g9eca6cc66a-dirty (Jun 08 2022 - 09:40:52 +0200)
My understanding, at least for the i.MX8MM case, is that mainline TF-A does not support HAB, so the NXP TF-A should be used if HAB support is required.
Please check: https://lists.trustedfirmware.org/archives/list/tf-a@lists.trustedfirmware.o...
Does the board boot with IMX_HAB=y with NXP TF-A?
Regards,
Fabio Estevam