Hi Chris,
Please update the subject with something like "Enable the VO PD before driver access",
and the commit message for the change reason is enough.
and the config is more soc level, I think you can add this to arch_cpu_init() for we don't have a power domain driver.
On 2024/9/17 05:01, Chris Morgan wrote:
From: Chris Morgan macromorgan@hotmail.com
The current panel detection logic crashes when the device boots with mainline A-TF, causing a reboot loop. It turns out mainline A-TF doesn't enable the VO power domain like the BSP A-TF did.
Set the VO domain on and use a memory barrier to ensure it is powered up before we attempt to do the panel detection.
Signed-off-by: Chris Morgan macromorgan@hotmail.com
board/anbernic/rgxx3_rk3566/rgxx3-rk3566.c | 13 +++++++++++++ configs/anbernic-rgxx3-rk3566_defconfig | 2 -- 2 files changed, 13 insertions(+), 2 deletions(-)
diff --git a/board/anbernic/rgxx3_rk3566/rgxx3-rk3566.c b/board/anbernic/rgxx3_rk3566/rgxx3-rk3566.c index c1d1826fd14..f4e7c1ab360 100644 --- a/board/anbernic/rgxx3_rk3566/rgxx3-rk3566.c +++ b/board/anbernic/rgxx3_rk3566/rgxx3-rk3566.c @@ -22,6 +22,10 @@
DECLARE_GLOBAL_DATA_PTR;
+#define PMU_BASE_ADDR 0xfdd90000 +#define PMU_PWR_GATE_SFTCON 0xa0 +#define PMU_PD_VO_DWN_ENA BIT(7)
- #define GPIO0_BASE 0xfdd60000 #define GPIO4_BASE 0xfe770000 #define GPIO_SWPORT_DR_L 0x0000
@@ -311,6 +315,15 @@ int rgxx3_detect_display(void) int i; u8 panel_id[2];
- /* Disable VO power domain power-down */
Disable?
- writel((PMU_PD_VO_DWN_ENA << 16),
PMU_BASE_ADDR + PMU_PWR_GATE_SFTCON);- /*
* System will crash if the power domain isn't enabled before* we start trying to talk to the DSI panel.*/- wmb();
- /*
- Take panel out of reset status.
- Set GPIO4_A0 to output.
diff --git a/configs/anbernic-rgxx3-rk3566_defconfig b/configs/anbernic-rgxx3-rk3566_defconfig index f5e5470df8c..49d3766613e 100644 --- a/configs/anbernic-rgxx3-rk3566_defconfig +++ b/configs/anbernic-rgxx3-rk3566_defconfig @@ -49,8 +49,6 @@ CONFIG_SPL_REGMAP=y CONFIG_SPL_SYSCON=y CONFIG_SPL_ADC=y CONFIG_SPL_CLK=y -CONFIG_ARM_SMCCC_FEATURES=y -CONFIG_SCMI_FIRMWARE=y
This should be a separate patch, and what's the change?
Thanks,
- Kever
CONFIG_ROCKCHIP_GPIO=y CONFIG_SYS_I2C_ROCKCHIP=y CONFIG_MISC=y