On 8/8/22 16:53, Stefan Herbrechtsmeier wrote:
From: Stefan Herbrechtsmeier stefan.herbrechtsmeier@weidmueller.com
The drivers informs the user that a post config was not run after FPGA configuration. This message is unnecessary in SPL because the ps7_post_config function is called via spl_board_prepare_for_boot function before jump_to_image_no_args function from board_init_r function.
Signed-off-by: Stefan Herbrechtsmeier stefan.herbrechtsmeier@weidmueller.com
drivers/fpga/zynqpl.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/fpga/zynqpl.c b/drivers/fpga/zynqpl.c index d8ebd542ab..0c83df46da 100644 --- a/drivers/fpga/zynqpl.c +++ b/drivers/fpga/zynqpl.c @@ -413,7 +413,8 @@ static int zynq_load(xilinx_desc *desc, const void *buf, size_t bsize, if (bstype != BIT_PARTIAL) zynq_slcr_devcfg_enable();
- puts("INFO:post config was not run, please run manually if needed\n");
if (!IS_ENABLED(CONFIG_SPL_BUILD))
puts("INFO:post config was not run, please run manually if needed\n");return FPGA_SUCCESS; }
Applied. M