On 24/01/20 1:46 am, Sagar Shrikant Kadam wrote:
This patch adds a workaround to change the read/write opcodes from QUAD to single bit mode. Idea here is to enable usage of spi-flash on the board.
TODO: -Enable QUAD mode for spi-flash on HiFive Unleashed A00 board.
Signed-off-by: Sagar Shrikant Kadam sagar.kadam@sifive.com
drivers/mtd/spi/spi-nor-core.c | 15 ++++++++++++++- 1 file changed, 14 insertions(+), 1 deletion(-)
diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c index c55116f..35d7772 100644 --- a/drivers/mtd/spi/spi-nor-core.c +++ b/drivers/mtd/spi/spi-nor-core.c @@ -295,7 +295,19 @@ static void spi_nor_set_4byte_opcodes(struct spi_nor *nor, nor->erase_opcode = SPINOR_OP_SE; nor->mtd.erasesize = info->sector_size; break;
+#ifdef CONFIG_TARGET_SIFIVE_FU540
- /*
* This flash device does support QUAD bit mode. But* with tx-rx width specified to 4 bit mode in dt the spi* driver is unable to access flash device. TODO: Once basic* operational support is moved to mainline remove this workaround.*/- case SNOR_MFR_ISSI:
nor->read_opcode = SPINOR_OP_READ_FAST;nor->program_opcode = SPINOR_OP_PP;break;+#endif
- default:
NACK.
Sorry, no Target specific #if'dery hacks in spi-nor-core please. Either debug and fix the issue or set tx-rx width to values that actually work in the mainline. You can switch tx-rx width to 4 when TODO is actually done.
break;}
@@ -2636,6 +2648,7 @@ int spi_nor_scan(struct spi_nor *nor) /* enable 4-byte addressing if the device exceeds 16MiB */ nor->addr_width = 4; if (JEDEC_MFR(info) == SNOR_MFR_SPANSION ||
JEDEC_MFR(info) == SNOR_MFR_ISSI ||#else