From the current documentation it is not entirely obvious where to take
some of the u-boot build artifacts in order to flash them to the sd card. Extend the "Program the SD card" block by providing relative paths to the jh7110-starfive-visionfive-2.dtb and u-boot-spl.bin.normal.out files.
Add "$(linux_image_dir)/" prefix to the Image.gz and initramfs.cpio.gz files in order to provide some information about where they could be taken from.
Signed-off-by: Ivan Orlov ivan.orlov0322@gmail.com --- doc/board/starfive/visionfive2.rst | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/doc/board/starfive/visionfive2.rst b/doc/board/starfive/visionfive2.rst index abda8ac21b..031d66fbfb 100644 --- a/doc/board/starfive/visionfive2.rst +++ b/doc/board/starfive/visionfive2.rst @@ -103,15 +103,15 @@ Program the SD card
.. code-block:: bash
- sudo dd if=u-boot-spl.bin.normal.out of=/dev/sdb1 + sudo dd if=spl/u-boot-spl.bin.normal.out of=/dev/sdb1 sudo dd if=u-boot.itb of=/dev/sdb2
sudo mount /dev/sdb3 /mnt/ - sudo cp u-boot-spl.bin.normal.out /mnt/ + sudo cp spl/u-boot-spl.bin.normal.out /mnt/ sudo cp u-boot.itb /mnt/ - sudo cp Image.gz /mnt/ - sudo cp initramfs.cpio.gz /mnt/ - sudo cp jh7110-starfive-visionfive-2.dtb /mnt/ + sudo cp $(linux_image_dir)/Image.gz /mnt/ + sudo cp $(linux_image_dir)/initramfs.cpio.gz /mnt/ + sudo cp arch/riscv/dts/jh7110-starfive-visionfive-2.dtb /mnt/ sudo umount /mnt
Booting