On Fri, Feb 25, 2022 at 2:43 PM Marek Vasut marex@denx.de wrote:
On 2/25/22 21:10, Adam Ford wrote:
On Fri, Feb 25, 2022 at 2:08 PM Marek Vasut marex@denx.de wrote:
On 2/25/22 19:29, Adam Ford wrote:
Some boards like the Beacon RZ/G2 SOM use either flags for tx-internal-delay-ps, rx-internal-delay-ps or rgmii-rxid.
In Linux the APSR_RDM flag is set when either rx-internal-delay-ps is set or the mode is rgmii-rxid, and the APSR_TDM is set when tx-internal-delay-ps is found or rgmii-txid is set, and both are set if rgmii-id is set.
The ravb driver in U-Boot driver was missing rgmii-rxid support, so add that support in a similar fashion to what is done in Linux.
Signed-off-by: Adam Ford aford173@gmail.com
V2: Add boolean for explit delays which skips the rgmii mode check if explicit delays are set. This more closely matches the behavior in Linux. Also add the same comments for the delays to match the comments found in Linux.
diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c index 1d1118c341..7bc8c84aaa 100644 --- a/drivers/net/ravb.c +++ b/drivers/net/ravb.c @@ -52,6 +52,7 @@ #define CSR_OPS 0x0000000F #define CSR_OPS_CONFIG BIT(1)
+#define APSR_RDM BIT(13) #define APSR_TDM BIT(14)
#define TCCR_TSRQ0 BIT(0) @@ -376,6 +377,9 @@ static int ravb_dmac_init(struct udevice *dev) struct ravb_priv *eth = dev_get_priv(dev); struct eth_pdata *pdata = dev_get_plat(dev); int ret = 0;
int mode = 0;unsigned int delay;bool explicit_delay = false; /* Set CONFIG mode */ ret = ravb_reset(dev);@@ -402,9 +406,33 @@ static int ravb_dmac_init(struct udevice *dev) (rmobile_get_cpu_type() == RMOBILE_CPU_TYPE_R8A77995)) return 0;
if ((pdata->phy_interface == PHY_INTERFACE_MODE_RGMII_ID) ||(pdata->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID))writel(APSR_TDM, eth->iobase + RAVB_REG_APSR);
if (!dev_read_u32(dev, "tx-internal-delay-ps", &delay)) {/* Valid values are 0 and 2000, according to DT bindings */if (delay) {mode |= APSR_TDM;explicit_delay = true;}}if (!dev_read_u32(dev, "rx-internal-delay-ps", &delay)) {/* Valid values are 0 and 1800, according to DT bindings */if (delay) {mode |= APSR_RDM;explicit_delay = true;}}Any reason to reverse those two tests compared to Linux ? Linux does rx test before tx test, and keeps the tests sorted alphabetically.
It wasn't intentional. I can swap them.
V3 is now applied and in CI.
Thank you!
Just as an FYI, you are not showing up as a maintainer for the ravb driver when run check_maintainer.py. I knew to add you to the CC list, but others in the future may not know to do that.
adam