On Wed, Dec 11, 2019 at 7:49 AM Fabio Estevam festevam@gmail.com wrote:
Following the README instructions leads to a non-booting U-Boot:
U-Boot SPL 2020.01-rc3-00070-g9a0cbae22a (Nov 25 2019 - 13:08:24 -0300) PMIC: PFUZE100 ID=0x10 DDRINFO: start DRAM init DDRINFO:ddrphy calibration done DDRINFO: ddrmix config done Normal Boot Trying to boot from MMC2
(It hangs here)
Use the "imx_4.19.35_1.0.0" ATF branch instead, which fixes such problem and allow the boot to complete again.
Shouldn't we address the mix-match of the firmware-imx versions as well?
I just increasing numbers over and over, and I was able to use firmware 8.5 which.
The readme lists both 7.9 and 8.0. There is also a typo on the line that reads "./firmware-imx-8.0" which should have a .bin appended to it.
It would nice to know what the differences are between the versions.
adam
Suggested-by: Adam Ford aford173@gmail.com Signed-off-by: Fabio Estevam festevam@gmail.com
board/freescale/imx8mq_evk/README | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/board/freescale/imx8mq_evk/README b/board/freescale/imx8mq_evk/README index c1d400bcf9..4f671b069c 100644 --- a/board/freescale/imx8mq_evk/README +++ b/board/freescale/imx8mq_evk/README @@ -11,7 +11,7 @@ Get and Build the ARM Trusted firmware ====================================== Note: srctree is U-Boot source directory Get ATF from: https://source.codeaurora.org/external/imx/imx-atf -branch: imx_4.14.62_1.0.0_beta +branch: imx_4.19.35_1.0.0 $ make PLAT=imx8mq bl31 $ cp build/imx8mq/release/bl31.bin $(srctree)
-- 2.17.1