25 Nov
2013
25 Nov
'13
4:06 p.m.
Hi Stefano,
On Mon, Nov 18, 2013 at 1:51 PM, Stefano Babic sbabic@denx.de wrote:
Hi Giuseppe,
On 15/11/2013 17:42, Giuseppe Pagano wrote:
Add Ethernet and networking support on uDoo board (FEC +phy Micrel KSZ9031). Ethernet speed is currently limited to 10/100Mbps.
Signed-off-by: Giuseppe Pagano giuseppe.pagano@seco.com Tested-by: Fabio Estevam fabio.estevam@freescale.com CC: Stefano Babic sbabic@denx.de CC: Fabio Estevam fabio.estevam@freescale.com
IMHO the patch is ok. If there are not any further comments, I mark your patchset for merging.
Please apply this series when you have a chance.
I would like to send some other patches to udoo board that depends on this series.
Regards,
Fabio Estevam