Re: [U-Boot] [v3 PATCH 1/3] arm: mxs: Add debug outputs and comments to mxs SPL source files

On 25/01/2015 02:07, Graeme Russ wrote:

It is difficult to track down fail to boot issues in the mxs SPL. Implement the following to make it easier:

• Add debug outputs to allow tracing of SPL progress in order to track

where failure to boot occurs. DEUBUG and CONFIG_SPL_SERIAL_SUPPORT must be defined to enable debug output in SPL

• Add TODO comments where it is not clear if the code is doing what it

is meant to be doing, even tough the board boots properly (these comments refer to existing code, not to any code added by this patch)

Signed-off-by: Graeme Russ gruss@tss-engineering.com

Applied to u-boot-imx, thanks !

Best regards, Stefano Babic