Re: [U-Boot] [PATCH v3 2/3] spi: zynqmp_qspi: Add QSPI driver support for ZynqMP

Hi Jagan,

On Wed, Jul 27, 2016 at 1:28 PM, Jagan Teki jagannadh.teki@gmail.com wrote:

On 19 July 2016 at 14:40, Siva Durga Prasad Paladugu siva.durga.paladugu@xilinx.com wrote:

...

This adds QSPI driver support for ZynqMP platform This driver supports all spi flash commands in qspi single mode.

Signed-off-by: Siva Durga Prasad Paladugu sivadur@xilinx.com

Changes for v3:

• None

Changes for v2:

• set no_all_quad as zynqmp qspi controller doesnt support it

---

drivers/spi/Kconfig | 9 + drivers/spi/Makefile | 1 + drivers/spi/zynqmp_qspi.c | 705 ++++++++++++++++++++++++++++++

++++++++++++++++

...

3 files changed, 715 insertions(+) create mode 100644 drivers/spi/zynqmp_qspi.c

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig index aca385d..6814ff9 100644 --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig @@ -172,6 +172,15 @@ config ZYNQ_QSPI Zynq QSPI IP core. This IP is used to connect the flash in 4-bit qspi, 8-bit dual stacked and shared 4-bit dual parallel.

+config ZYNQMP_QSPI

•   bool "ZynqMP QSPI driver"
  

•   depends on ARCH_ZYNQMP
  

•   help
  

•     Enable the ZynqMP Quad-SPI (QSPI) driver. This driver can be
  

•     used to access the SPI NOR flash on platforms embedding this
  

•     ZynqMP QSPI IP core. This IP is used to connect the flash in
  

•     4-bit qspi, 8-bit dual stacked and shared 4-bit dual parallel.
  

If this is the case, spi couldn't be the correct place to handle nor dualness.

But i see zynq also added here. If this not the correct place could you please point me to where this should go.

Regards, Siva

thanks!

Jagan. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot