From: Max Krummenacher max.krummenacher@toradex.com
If the UART is used in DTE mode the RI and DCD bits in UCR3 become irq enable bits. Both are set to enabled after reset and both likely are pending.
Disable the bits also on UARTs not used in the boot loader to prevent an interrupt storm when Linux enables the UART interrupts.
Signed-off-by: Max Krummenacher max.krummenacher@toradex.com Acked-by: Marcel Ziswiler marcel.ziswiler@toradex.com
---
Changes in v2: None
board/toradex/apalis_imx6/apalis_imx6.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)
diff --git a/board/toradex/apalis_imx6/apalis_imx6.c b/board/toradex/apalis_imx6/apalis_imx6.c index cfdadda939..2c90a40042 100644 --- a/board/toradex/apalis_imx6/apalis_imx6.c +++ b/board/toradex/apalis_imx6/apalis_imx6.c @@ -238,8 +238,11 @@ iomux_v3_cfg_t const usb_pads[] = { * UARTs are used in DTE mode, switch the mode on all UARTs before * any pinmuxing connects a (DCE) output to a transceiver output. */ +#define UCR3 0x88 /* FIFO Control Register */ +#define UCR3_RI BIT(8) /* RIDELT DTE mode */ +#define UCR3_DCD BIT(9) /* DCDDELT DTE mode */ #define UFCR 0x90 /* FIFO Control Register */ -#define UFCR_DCEDTE (1<<6) /* DCE=0 */ +#define UFCR_DCEDTE BIT(6) /* DCE=0 */
static void setup_dtemode_uart(void) { @@ -247,6 +250,11 @@ static void setup_dtemode_uart(void) setbits_le32((u32 *)(UART2_BASE + UFCR), UFCR_DCEDTE); setbits_le32((u32 *)(UART4_BASE + UFCR), UFCR_DCEDTE); setbits_le32((u32 *)(UART5_BASE + UFCR), UFCR_DCEDTE); + + clrbits_le32((u32 *)(UART1_BASE + UCR3), UCR3_DCD | UCR3_RI); + clrbits_le32((u32 *)(UART2_BASE + UCR3), UCR3_DCD | UCR3_RI); + clrbits_le32((u32 *)(UART4_BASE + UCR3), UCR3_DCD | UCR3_RI); + clrbits_le32((u32 *)(UART5_BASE + UCR3), UCR3_DCD | UCR3_RI); } static void setup_dcemode_uart(void) {