[U-Boot-Users] Using uec.c and uec_phy.c

Hi,

I am using the polled uboot ethernet driver on MPC8360erdk. I have trouble sending and receiving ethernet packets. I have configured the interface as a generic MII and it detects the linking coming up. However when the QUICC engine reads TXBD and indicates TX is complete, nothing comes on the wire. This I confirmed using ethereal. Also on the RX side if connected to a PC I get RX error. I have made no changes to the orginial code. The interface is a BCM5481 on the board.

Any pointer will be appreciated.

Sampath