On Thu, Dec 05, 2013 at 05:54:21PM +0530, pekon gupta wrote:
As per OMAP3530 TRM referenced below [1]
For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme
- OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device
- OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device
Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is: *for x8 NAND Device* +--------+---------+---------+---------+---------+---------+---------+ | xxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ... +--------+---------+---------+---------+---------+---------+---------+
*for x16 NAND Device* +--------+--------+---------+---------+---------+---------+---------+---------+ | xxxxx | xxxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | +--------+--------+---------+---------+---------+---------+---------+---------+
This patch fixes ecc-layout *only* for HAM1, as required by ROM-code For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices.
[1] OMAP3530: http://www.ti.com/product/omap3530 TRM: http://www.ti.com/litv/pdf/spruf98x Chapter-25: Initialization Sub-topic: Memory Booting Section: 25.4.7.4 NAND Figure 25-19. ECC Locations in NAND Spare Areas
Reported-by: Stefan Roese sr@denx.de Signed-off-by: Pekon Gupta pekon@ti.com Tested-by: Stefan Roese sr@denx.de
drivers/mtd/nand/omap_gpmc.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-)
Applied to u-boot-nand-flash.git
-Scott