Hello Eric,
Eric Millbrandt wrote:
Reset any i2c devices that may have been interrupted by a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). But since there is only write access to these lines on the MPC5200 we can only attempt to reset any slave devices by sending more start commands than bits the slave is attempting to transmit.
Signed-off-by: Eric Millbrandt emillbrandt@dekaresearch.com
Changes since v1:
- Remove non-related modifications to a different patch per Peter's suggestion
one common comment:
Can you please use in_*/out_* accessors for accessing mpc52xx registers.
board/galaxy5200/galaxy5200.c | 41 +++++++++++++++++++++++++++++++++++++++++ include/configs/galaxy5200.h | 1 + 2 files changed, 42 insertions(+), 0 deletions(-)
diff --git a/board/galaxy5200/galaxy5200.c b/board/galaxy5200/galaxy5200.c index 5aa9d3a..c38e7de 100644 --- a/board/galaxy5200/galaxy5200.c +++ b/board/galaxy5200/galaxy5200.c @@ -155,6 +155,47 @@ phys_size_t initdram(int board_type) return dramsize + dramsize2; }
+/*
- Reset any i2c devices that may have been interrupted by a system reset.
- Normally this would be accomplished by clocking the line until SCL and SDA
- are released and then sending a start condtiion (From an Atmel datasheet).
- But since there is only write access to these lines on the MPC5200 we can
- only attempt to reset any slave devices by sending more start commands than
- bits the slave is attempting to transmit.
- */
+int misc_init_f(void)
Hmm.. why in misc_init_f? Can you move this function to the mpc52xx i2c driver, and add this in a manner like the send_reset() function in drivers/i2c/soft_i2c.c? And call this send_reset() in the i2c_init() from the mpc52xx i2c driver. As I don;t know, if this is valid for all mpc52xx boards, it should be then also per CONFIG_SYS_* define selectable.
thanks.
bye Heiko