* add link to booti man-page * correct link description for efidebug command * correct punctuation
Signed-off-by: Heinrich Schuchardt heinrich.schuchardt@canonical.com --- doc/usage/cmd/bootefi.rst | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-)
diff --git a/doc/usage/cmd/bootefi.rst b/doc/usage/cmd/bootefi.rst index 282f22aac9..31279fc0cb 100644 --- a/doc/usage/cmd/bootefi.rst +++ b/doc/usage/cmd/bootefi.rst @@ -24,7 +24,7 @@ The *bootefi* command is used to launch a UEFI binary which can be either of * UEFI run-time services driver
An operating system requires a hardware description which can either be -presented as ACPI table (CONFIG_GENERATE_ACPI_TABLE=y) or as device-tree +presented as ACPI table (CONFIG_GENERATE_ACPI_TABLE=y) or as device-tree. The load address of the device-tree may be provided as parameter *fdt_addr*. If this address is not specified, the bootefi command will try to fall back in sequence to: @@ -123,6 +123,7 @@ Configuration -------------
To use the *bootefi* command you must specify CONFIG_CMD_BOOTEFI=y. +The *bootefi bootmgr* sub-command requries CMD_BOOTEFI_BOOTMGR=y. The *bootefi hello* sub-command requries CMD_BOOTEFI_HELLO=y. The *bootefi selftest* sub-command depends on CMD_BOOTEFI_SELFTEST=y.
@@ -130,6 +131,6 @@ See also --------
* *bootm* for launching UEFI binaries packed in FIT images -* *booti*, *bootm*, *bootz* for launching a Linux kernel without using the - UEFI sub-system -* *efidebug* for setting UEFI boot variables +* :doc:`booti<booti>`, *bootm*, *bootz* for launching a Linux kernel without + using the UEFI sub-system +* *efidebug* for setting UEFI boot variables and boot options