Dear "Dexdyne Postmaster",
whoops - fixed that now!!!
This depends on your configuration. When using an "embedded" environment, this will get replaced with each install.
" this will get replaced with each install "
sorry - I don't know how you mean that will happen....
OK - I'm working on an AVR32 - if I follow the instructions they give, it replaces the u-boot code, and leaves the environment sector in flash unchanged. I have added a 1-byte-write to the sector to my script to corrupt it.... but a command would be easier.
Worse, there doesn't seem to be a command to say "over-write that with your new defaults"
You can run a script image that does whatever you want.
OK again - I don't seem to have scripting enabled in my u-boot - I'd like to do that so I can use && in by boot sequence.
What would I put in a script to have the effect of forcing a load of the new defaults??? If there's no single command, do you mean I could make up a script full of "set" commands?
If that is indeed so, then can I propose such a command should be added?
Search the archives. There has been a proposal before, and even an API has been agreed on, it's just that nobody implemented it yet. Patches are welcome.
I did some reading last night, and did indeed find the proposed implementation on the to-do list ....
Thanks
David Collier
www.dexdyne.com