Re: [U-Boot-Users] R: Booting with attached BDI butnot alone (onlyICTRL remained in BDI cfg)

Have you used a voltage meter or oscilloscope to check the voltage level? Have you measured the resistance between SRESET and GND and between SRESET and supply? Have you checked if your processor pin is connected? Probably either the pull-up resistor isn't mounted or your PCB is defective.

Thank you for your suggestions but my board is an evaluation board named adder875. It worked and after connecting a wiggler with the connector upside down exibihts this strange behaviour. Anyway I will measure the voltage of the pins you suggested.

Bye, Antonio.