From: Andreas Dannenberg dannenberg@ti.com
Make the wkup_i2c0 module usable across all stages of U-Boot by adding the needed definitions including the associated pinmux definitions.
Signed-off-by: Andreas Dannenberg dannenberg@ti.com Signed-off-by: Lokesh Vutla lokeshvutla@ti.com --- .../dts/k3-j721e-common-proc-board-u-boot.dtsi | 8 ++++++++ arch/arm/dts/k3-j721e-common-proc-board.dts | 15 +++++++++++++++ 2 files changed, 23 insertions(+)
diff --git a/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi b/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi index 9291e57e25..e54b2a7e70 100644 --- a/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi +++ b/arch/arm/dts/k3-j721e-common-proc-board-u-boot.dtsi @@ -311,3 +311,11 @@ reg-names = "gmii-sel"; }; }; + +&wkup_i2c0_pins_default { + u-boot,dm-spl; +}; + +&wkup_i2c0 { + u-boot,dm-spl; +}; diff --git a/arch/arm/dts/k3-j721e-common-proc-board.dts b/arch/arm/dts/k3-j721e-common-proc-board.dts index c978cabd13..f4366f9f87 100644 --- a/arch/arm/dts/k3-j721e-common-proc-board.dts +++ b/arch/arm/dts/k3-j721e-common-proc-board.dts @@ -77,3 +77,18 @@ voltage-ranges = <1800 1800 3300 3300>; ti,driver-strength-ohm = <50>; }; + +&wkup_pmx0 { + wkup_i2c0_pins_default: wkup-i2c0-pins-default { + pinctrl-single,pins = < + J721E_WKUP_IOPAD(0xf8, PIN_INPUT_PULLUP, 0) /* (J25) WKUP_I2C0_SCL */ + J721E_WKUP_IOPAD(0xfc, PIN_INPUT_PULLUP, 0) /* (H24) WKUP_I2C0_SDA */ + >; + }; +}; + +&wkup_i2c0 { + pinctrl-names = "default"; + pinctrl-0 = <&wkup_i2c0_pins_default>; + clock-frequency = <400000>; +};