- extend the discussion of USB network related config options such that all available adapter drivers are listed, and that the 'usb' command for the interactive prompt and scripting becomes available - suggest to *not* put individual IP configuration parameters into the exectuable, but instead to put them into external environment or fetch them from network
Signed-off-by: Gerhard Sittig gsi@denx.de Acked-by: Simon Glass sjg@chromium.org ---
Changes in v4: None
Changes in v3: - pick up Simon's ACKs for individual patches
Changes in v2: - introduce the patch to update README.usb for USB ethernet options
doc/README.usb | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/doc/README.usb b/doc/README.usb index 65fb2886d958..bc768a385450 100644 --- a/doc/README.usb +++ b/doc/README.usb @@ -127,8 +127,14 @@ To enable USB Host Ethernet in U-Boot, your platform must of course support USB with CONFIG_CMD_USB enabled and working. You will need to add some config settings to your board header file:
+#define CONFIG_CMD_USB /* the 'usb' interactive command */ #define CONFIG_USB_HOST_ETHER /* Enable USB Ethernet adapters */ -#define CONFIG_USB_ETHER_ASIX /* Asix, or whatever driver(s) you want */ + +and one or more of the following for individual adapter hardware: + +#define CONFIG_USB_ETHER_ASIX +#define CONFIG_USB_ETHER_MCS7830 +#define CONFIG_USB_ETHER_SMSC95XX
As with built-in networking, you will also want to enable some network commands, for example: @@ -148,7 +154,10 @@ settings should start you off:
You can also set the default IP address of your board and the server as well as the default file to load when a 'bootp' command is issued. -All of these can be obtained from the bootp server if not set. +However note that encoding these individual network settings into a +common exectuable is discouraged, as it leads to potential conflicts, +and all the parameters can either get stored in the board's external +environment, or get obtained from the bootp server if not set.
#define CONFIG_IPADDR 10.0.0.2 (replace with your value) #define CONFIG_SERVERIP 10.0.0.1 (replace with your value)