Hi,
I've tried to flash TOT u-boot complied with ELDK 4.2 for P1020_config into my P1020RDB RevD and bricked it. The same u-boot boots fine on P2020RDB revC.
I don't have BDI3000 at the moment to debug the problem. It would be great to fix it before the release.
Below is u-boot output from P1020RDB running with u-boot-2009.11 from FSL BSP
U-Boot 2009.11-00001-g4458602-dirty (Feb 27 2010 - 11:13:42)
CPU0: P1020E, Version: 1.0, (0x80ec0010) Core: E500, Version: 5.0, (0x80212050) Clock Configuration: CPU0:800 MHz, CPU1:800 MHz, CCB:400 MHz, DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:25 MHz L1: D-cache 32 kB enabled I-cache 32 kB enabled Board: P1020RDB RevD I2C: ready SPI: ready DRAM: Configuring DDR for 666.667 MT/s data rate DDR: 512 MB NOR Flash Bank : Primary SD/MMC : 4-bit Mode eSPI : Enabled FLASH: 16 MB L2: 256 KB enabled NAND: 32 MiB MMC: FSL_ESDHC: 0 EEPROM: Read failed. eTSEC2 is in sgmii mode.
PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000) PCIE2 on bus 00 - 01
PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000) PCIE1 on bus 02 - 02
In: serial Out: serial Err: serial Net: uploading VSC7385 microcode from ef000000 eTSEC1: No support for PHY id ffffffff; assuming generic eTSEC1, eTSEC2, eTSEC3
Thanks.
Felix.