Hi All,
It seems there's a regression in 2019.04 when booting the BBone Black Wireless off the onboard eMMC. It works fine if I boot off the SD card.
It complains about not being about to see a partition, and manual poking it will see the partitions and load from them, this previously booted fine with 2019.01. Looking through various logs I can't see where/why this changed.
Peter
U-Boot SPL 2019.04-rc4 (Mar 20 2019 - 15:03:10 +0000) Trying to boot from MMC2 Loading Environment from FAT... Card did not respond to voltage select!
U-Boot 2019.04-rc4 (Mar 20 2019 - 15:03:10 +0000)
CPU : AM335X-GP rev 2.1 Model: TI AM335x BeagleBone Black DRAM: 512 MiB NAND: 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 Loading Environment from FAT... MMC: no card present <ethaddr> not set. Validating first E-fuse MAC Net: Could not get PHY for ethernet@4a100000: addr 0 eth0: ethernet@4a100000 Warning: usb_ether MAC addresses don't match: Address in ROM is de:ad:be:ef:00:01 Address in environment is 50:65:83:da:68:eb , eth1: usb_ether Hit any key to stop autoboot: 0 MMC: no card present MMC: no card present MMC: no card present MMC: no card present MMC: no card present MMC: no card present switch to partitions #0, OK mmc1(part 0) is current device SD/MMC found on device 1 ** No partition table - mmc 1 ** ** No partition table - mmc 1 ** ## Error: "bootcmd_nand0" not defined starting USB... USB0: Port not available. using musb-hdrc, OUT ep1out IN ep1in STATUS ep2in MAC de:ad:be:ef:00:01
<snip attempts at network boot off usb>
The remote end did not respond in time.=> => mmc list OMAP SD/MMC: 0 OMAP SD/MMC: 1 (eMMC) => mmc dev 1 switch to partitions #0, OK mmc1(part 0) is current device => mmc part
Partition Map for MMC device 1 -- Partition Type: DOS
Part Start Sector Num Sectors UUID Type 1 2048 202753 ff24dd7d-01 ef Boot 2 204801 1355775 ff24dd7d-02 83 Boot 4 1560576 5910528 ff24dd7d-04 83 =>