Tried with loady command in u-boot and ymodem option from minicom. With this combination I am able to transfer and run uImage.
~cnanda
On Sat, Jan 30, 2010 at 10:02 PM, Wolfgang Denk wd@denx.de wrote:
Dear Chetan Nanda,
In message 7f245da81001300735x6d0727f8s2f530d6a3540e2b5@mail.gmail.com you wrote:
Every time after this transfer get started but then aborted automatically with following error message:
...
HINTS... If the preceding error message does not explain the failure: . Try changing the remote Kermit's FLOW-CONTROL setting. . Increase the retry limit (see HELP SET RETRY). . Try it again with SET STREAMING OFF. . Try it again with SET PARITY SPACE. . As a last resort, give a ROBUST command and try again.
So - have you tried any of these hints?
The kermit developer tried the best they could do to help you by providing valuable hints for configuration settings that might help to solve your problem - and did you follow their advice?
Also, did you RTFM? The manual contains a section on how to configure kermit for reliable work:
http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3.
Did you really adapt your ~/.kermrc as recommended?
Best regards,
Wolfgang Denk
-- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de "Bureaucracy is the enemy of innovation." - Mark Shepherd, former President and CEO of Texas Instruments