Hi Joe,
On Tue, 2016-01-19 at 07:02 +0000, Alexey Brodkin wrote:
Hi Joe,
On Wed, 2016-01-13 at 16:59 +0300, Alexey Brodkin wrote:
In some cases Ethernet PHY and network itself might support speeds which are not supported by Ethernet controller (MAC).
To support that kind of situation it is required to force limit PHY so it is not configured for unsupported mode or even if PHY autonegotiated too high speed it will be reconfigured for slower mode.
Note this series is v2 because v1 patches were sent separately not being aranged in series. And now I'm putting all patches in one series and marking it v2 even though no changes were done in patches itself.
Alexey Brodkin (4): drivers/net/phy: introduce phy_set_supported() include/net.h: add max_speed member in struct eth_pdata net/designware: do explicit port selection for 1Gb mode net/designware: add support of max-speed device tree property
Florian Fainelli (2): net: phy: ensure Gigabit features are masked off if requested net: phy: breakdown PHY_*_FEATURES defines
Sascha Hauer (1): net: phy: genphy: Allow overwriting features
drivers/net/designware.c | 16 +++++++++- drivers/net/designware.h | 1 + drivers/net/phy/phy.c | 77 ++++++++++++++++++++++++++++++++++-------------- include/net.h | 2 ++ include/phy.h | 23 ++++++++++----- 5 files changed, 89 insertions(+), 30 deletions(-)
Please treat this as a polite reminder to review that series sometime soon.
Thank you for reviewing that series. I'm wondering who's going to pick it up?
-Alexey