When using include directives within a section that is included by non TI board rst file, k3.rst and other include paths need to be relative to doc/board/ base.
Signed-off-by: Nishanth Menon nm@ti.com --- doc/board/ti/j721e_evm.rst | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/doc/board/ti/j721e_evm.rst b/doc/board/ti/j721e_evm.rst index 344a38d37486..b012171b45ee 100644 --- a/doc/board/ti/j721e_evm.rst +++ b/doc/board/ti/j721e_evm.rst @@ -48,7 +48,7 @@ support. Below is the pictorial representation of boot flow: Sources: --------
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_boot_sources :end-before: .. k3_rst_include_end_boot_sources
@@ -56,17 +56,17 @@ Build procedure: ---------------- 0. Setup the environment variables:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_common_env_vars_desc :end-before: .. k3_rst_include_end_common_env_vars_desc
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_board_env_vars_desc :end-before: .. k3_rst_include_end_board_env_vars_desc
Set the variables corresponding to this platform:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_common_env_vars_defn :end-before: .. k3_rst_include_end_common_env_vars_defn .. prompt:: bash $ @@ -84,14 +84,14 @@ Set the variables corresponding to this platform:
1. Trusted Firmware-A:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_build_steps_tfa :end-before: .. k3_rst_include_end_build_steps_tfa
2. OP-TEE:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_build_steps_optee :end-before: .. k3_rst_include_end_build_steps_optee
@@ -99,13 +99,13 @@ Set the variables corresponding to this platform:
* 3.1 R5:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_build_steps_spl_r5 :end-before: .. k3_rst_include_end_build_steps_spl_r5
* 3.2 A72:
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_build_steps_uboot :end-before: .. k3_rst_include_end_build_steps_uboot .. j721e_evm_rst_include_end_build_steps @@ -248,7 +248,7 @@ detailed setup information. environment's distribution needs to be updated, it might be necessary to build OpenOCD from the source.
-.. include:: k3.rst +.. include:: ../ti/k3.rst :start-after: .. k3_rst_include_start_openocd_connect_XDS110 :end-before: .. k3_rst_include_end_openocd_connect_XDS110