Dear Matt Sealey,
On Sat, Aug 18, 2012 at 10:34 AM, Stefano Babic sbabic@denx.de wrote:
On 17/08/2012 20:19, Matt Sealey wrote:
The i.MX Boot ROM lets us set up certain registers before U-Boot even gets executed. Rather than setting up DDR, putting U-Boot in place, and getting into pre-relocation init to set up DDR again, just do it once in the correct place. This also solves an issue where the Smarttop DDR pad settings were being applied on Smartbook.
While we're at it, configure PCBID0,1,2 and the LED GPIO since we've still got room in the DCD to do so.
Signed-off-by: Matt Sealey matt@genesi-usa.com
Hi Matt,
diff --git a/board/genesi/mx51_efikamx/imximage_mx.cfg b/board/genesi/mx51_efikamx/imximage_mx.cfg index 6fe0ff9..ac9aa9a 100644 --- a/board/genesi/mx51_efikamx/imximage_mx.cfg +++ b/board/genesi/mx51_efikamx/imximage_mx.cfg @@ -1,7 +1,7 @@
#
+# Copyright (C) 2009 Pegatron Corporation
^---Was this added for mistake ? I think you should add only yours.
The drive strength settings came from Pegatron a long, long time ago (2009 :) and our old config and the function is copyrighted to them. Just because Marek took them out and recopyrighted the file I derived them from in this case doesn't mean they lost their copyright..
This file was taken from mx51evk. It's written there. Please stop this nonsense, it's troubling me.
I join Marek, it is quite difficult to review it and understand which was changed. It looks like a new file..
It's just because I moved the comments to the end of the line, so it's blocking it up.
Sometimes it's nicer if it's
-this line +that line -this line +that line
.. but that's not how git does it when the change is more than a few characters and multiple lines changed.. I can submit it differently but I can't change the way it's producing the diff.
Best regards, Marek Vasut