Yasothabalan Ramaswamy-TLS,Chennai wrote:
I am using I2C EEPROM.
I've forgotten what type of CPU you have. As long as there's a driver for the I2C controller and you've enabled I2C support, this is supported.
Ben I am having another issue now.
Here in my board I have two Ethernet ports; So now I have to set two different IP addresses for these ports.
As when the U-Boot prompt comes up we can set the IP address as,
=> set ipaddr 10.128.19.1 => set ethaddr aa:bb:cc:ee:ff:gg
So above setting is valid only for single Ethernet port.
My doubt how to set IP address for another Ethernet port or what is the method to do that?
{How can I set two different IP addresses for these two ports? [Two different IPs Two different GATEWAYs Two different SERVERIPs]}
The network code really only supports one IP address at a time, which will be used by whatever interface that the 'ethact' environment variable points to. What is your use case for setting up more elaborate networking?
regards, Ben