On Tue, Aug 23, 2016 at 08:05:59PM +0200, Marcus Glocker wrote:
On Mon, Aug 22, 2016 at 09:55:01AM +0200, Boris Brezillon wrote:
+Glaucio who is facing the same problem but on a cubieboard2.
On Sun, 21 Aug 2016 16:14:39 +0200 Boris Brezillon boris.brezillon@free-electrons.com wrote:
Hi,
On Sun, 21 Aug 2016 12:03:19 +0200 Hans de Goede hdegoede@redhat.com wrote:
Hi,
On 21-08-16 11:01, Marcus Glocker wrote:
On Sat, Aug 20, 2016 at 03:05:38PM -0400, Tom Rini wrote:
On Sat, Aug 20, 2016 at 07:26:19AM +0200, Marcus Glocker wrote: > Hello, > > While U-Boot SPL 2015.10 works fine on my allwinner,sun5i-r8 board I > face following issue with U-Boot SPL 2016.09-rc1 on it: > > bash-4.3# cu -l /dev/cuaU0 -s 115200 > Connected to /dev/cuaU0 (speed 115200) > > U-Boot SPL 2016.09-rc1 (Jul 31 2016 - 16:37:00) > DRAM: 512 MiB > CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2 > Trying to boot from NAND > ### ERROR ### Please RESET the board ### > > Any ideas what change did cause this or where to start looking after?
Markus, can you share your .config? I tested the different bits while submitting the NAND driver and the SPL NAND driver improvements and it was working fine. I'll try to test 2016.09-rc1 tomorrow.
Just tried to boot a mainline uboot on my CHIP and it boots fine [1]. Here is my .config [2], can you compare yours with this one?
Can you also detail how you flash the images?
Thanks for sharing your configuration! Based on that I was able to narrow down the configuration parameter which makes SPL 2016.09-rc1 now work on my allwinner,sun5i-r8 board as well:
+CONFIG_USE_PRIVATE_LIBGCC=n
When I don't set it explicitly I get 'CONFIG_USE_PRIVATE_LIBGCC=y' in my .config. Could it be that it was set to 'n' by default in previous releases?
What toolchain exactly are you using? Thanks!