Hi Dirk,
On 28 October 2015 at 04:46, dirk.eibach@gdsys.cc wrote:
From: Dirk Eibach dirk.eibach@gdsys.cc
Dirk Eibach (17): i2c: ihs_i2c: Dual channel support i2c: ihs_i2c: Use macro bestpractices i2c: ihs_i2c: Fix hold_bus control board: gdsys: Configure DP501 SPDIF input board: gdsys: Increase DP501 I2C retry interval board: gdsys: Consider DP501 limits on link training dlvision-10g: Support displayport controlcenterd: Disable sideband clocks hrcon: Remove CH7301 configuration mpc83xx: Add strider board hrcon: Use generic ioep-fpga support hrcon: Fix videoboard i2c setup hrcon: Add support for the DH variant hrcon: Add fan controllers board: gdsys: Add osdsize command board: gdsys: Enable osd on output only i2c: soft_i2c: Fix bus indizes
Reinhard Pfau (1): iocon: reset FPGAs in last_stage_init()
Would this be a good opportunity to convert these boards over to driver model for I2C?
Regards, Simon