From: Andrejs Cainikovs andrejs.cainikovs@toradex.com
Drive CTRL_SLEEP_MOCI# high at boot (SPL) using a GPIO hog, this signal may be used to control some power-rails on the carrier board, therefore it should be set to high when the module is booting.
To do this as early as possible is generally a good idea and the issue was noticed on the Yavia carrier board where it is needed to power the I2C EEPROM on the carrier board.
Signed-off-by: Andrejs Cainikovs andrejs.cainikovs@toradex.com Signed-off-by: Marcel Ziswiler marcel.ziswiler@toradex.com ---
arch/arm/dts/imx8mm-verdin-wifi-dev-u-boot.dtsi | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/arch/arm/dts/imx8mm-verdin-wifi-dev-u-boot.dtsi b/arch/arm/dts/imx8mm-verdin-wifi-dev-u-boot.dtsi index 494229e4e62..2b268f55cb9 100644 --- a/arch/arm/dts/imx8mm-verdin-wifi-dev-u-boot.dtsi +++ b/arch/arm/dts/imx8mm-verdin-wifi-dev-u-boot.dtsi @@ -56,6 +56,10 @@
&gpio5 { bootph-pre-ram; + + ctrl-sleep-moci-hog { + bootph-pre-ram; + }; };
&i2c1 { @@ -88,6 +92,10 @@ }; };
+&pinctrl_ctrl_sleep_moci { + bootph-pre-ram; +}; + &pinctrl_i2c1 { bootph-pre-ram; };