On Thu, Jan 4, 2024 at 12:02 PM Maxim Uvarov maxim.uvarov@linaro.org wrote:
CI tests this in all qemu emulated boards. I tested it locally on Raspberry Pi - works well. This version did not yet tested on imx8, but the previous version worked on eth0, did not work on eth1. So I plan to continue testing these patches on different boards. But in general it's the upper layer then drivers and theoretically has to work on any board. But in fact different boards work in different ways and behaviour is different with their qemu model. So I'm a little bit confused how to test and debug these patches on board which I don't have physical access...
Can you try to get access to any i.MX board via Linaro?
that is really strange, after reboot you should get the initial stage. You can type 'lwip list' and 'net list' to check if there is an IP address for active device set.
Nothing strange there:
u-boot=> lwip list 1: eth0 UP IP: 192.168.0.122/255.255.255.0, GW: 192.168.0.1, 00:04:9f:06:33:d3 done. u-boot=> net list eth0 : ethernet@30be0000 00:04:9f:06:12:98 active