3 May
2020
3 May
'20
12:30 p.m.
Hi,
To flash u-boot to iMX6ULL NAND, it requires using higher bits ECC (my imx6ulz_kobs.dtb) to run kobs-ng in ramdisk, but to flash rootfs image to NAND in ramdisk, I have to change to use lower ECC (my imx6ulz.dtb).
I followed the advice at link https://developer.toradex.com/knowledge-base/u-boot-fw-utils to run "fw_setenv fdt_file imx6ulz_kobs.dtb" before flashing u-boot to NAND, although the fw_setenv command worked, the u-boot wasn't installed properly in NAND, I could not boot from NAND.
What is the right way to run fw_setenv for changing different ECC or different dtb files?
Thank you.
Kind regards,
- jh
--
"A man can fail many times, but he isn't a failure until he begins to
blame somebody else."
-- John Burroughs