Re: [U-Boot] [U-Boot, v2, 3/3] clk: clk_stm32f: Move SYSCFG clock setup into configure_clocks()

On Thu, Jan 18, 2018 at 02:10:05PM +0100, patrice.chotard@st.com wrote:

From: Patrice Chotard patrice.chotard@st.com

Move SYSCFG clock setup into configure_clocks() instead of calling clock_setup() from board file.

As this clock is only needed in case of ethernet enabled and as both stm32f4 and stm32f7 are using the Designware ethernet IP, we use CONFIG_ETH_DESIGNWARE to only enable this clock if needed.

Move the RMII setup from board_early_init_f() to board_init() to insure that RMII bit is set only when clock driver is initialized.

Signed-off-by: Patrice Chotard patrice.chotard@st.com

Applied to u-boot/master, thanks!