I also have a 440GX eval board from IBM. I tried the ocotea config and it boots up just fine. However, I get a message about an I2C read error. Is this normal? In addition, I can't seem to bring up the network. However, this is my first shot with u-boot so probably I am doing something stupid. The docs I have found so far are pretty good, but relatively unclear on the network setup. Is there something I have to do besides setting some environment variables? Or is there some doc that I missed? Thanks.
-tc
---------------------------------------------------- IBM PowerPC 440 GX Rev. B Board: IBM 440GX Evaluation Board VCO: 1066 MHz CPU: 533 MHz PLB: 152 MHz OPB: 76 MHz EPB: 76 MHz I2C: ready DRAM: I2c read: failed 4 I2c read: failed 4 256 MB FLASH: 5 MB PCI: Bus Dev VenId DevId Class Int In: serial Out: serial Err: serial KGDB: kgdb ready ready Net: ppc_440x_eth0 BEDBUG:ready
=> printenv bootargs=root=/dev/hda1 bootcmd=bootm ffc00000 baudrate=115200 loads_echo=1 ethaddr=<macaddr> ipaddr=<ipaddr> netmask=<netmask> serverip=<servip> gatewayip=<gwip> hostname=<hostname> netdev=eth0 stdin=serial stdout=serial stderr=serial
Environment size: 278/4092 bytes
=> ping <address> Waiting for PHY auto negotiation to complete.. done ENET Speed is 100 Mbps - FULL duplex connection ping failed; host <address> is not alive
__________________________________ Do you Yahoo!? Yahoo! Small Business $15K Web Design Giveaway http://promotions.yahoo.com/design_giveaway/