It turns out that even though A64, H3 and H5 have custom PHY, standard hot plug detection for DW-HDMI works just fine.
Remove custom hpd method to reduce amount of custom code.
Signed-off-by: Jernej Skrabec jernej.skrabec@siol.net --- drivers/video/sunxi/sunxi_dw_hdmi.c | 34 +++++------------------------ 1 file changed, 6 insertions(+), 28 deletions(-)
diff --git a/drivers/video/sunxi/sunxi_dw_hdmi.c b/drivers/video/sunxi/sunxi_dw_hdmi.c index e3811a2ec15f..37e78ff24111 100644 --- a/drivers/video/sunxi/sunxi_dw_hdmi.c +++ b/drivers/video/sunxi/sunxi_dw_hdmi.c @@ -114,28 +114,6 @@ static void sunxi_dw_hdmi_phy_init(void) writel(0x42494E47, &phy->unscramble); }
-static int sunxi_dw_hdmi_get_plug_in_status(void) -{ - struct sunxi_hdmi_phy * const phy = - (struct sunxi_hdmi_phy *)(SUNXI_HDMI_BASE + HDMI_PHY_OFFS); - - return !!(readl(&phy->status) & (1 << 19)); -} - -static int sunxi_dw_hdmi_wait_for_hpd(void) -{ - ulong start; - - start = get_timer(0); - do { - if (sunxi_dw_hdmi_get_plug_in_status()) - return 0; - udelay(100); - } while (get_timer(start) < 300); - - return -1; -} - static void sunxi_dw_hdmi_phy_set(uint clock, int phy_div) { struct sunxi_hdmi_phy * const phy = @@ -370,12 +348,6 @@ static int sunxi_dw_hdmi_probe(struct udevice *dev)
sunxi_dw_hdmi_phy_init();
- ret = sunxi_dw_hdmi_wait_for_hpd(); - if (ret < 0) { - debug("hdmi can not get hpd signal\n"); - return -1; - } - priv->hdmi.ioaddr = SUNXI_HDMI_BASE; priv->hdmi.i2c_clk_high = 0xd8; priv->hdmi.i2c_clk_low = 0xfe; @@ -383,6 +355,12 @@ static int sunxi_dw_hdmi_probe(struct udevice *dev) priv->hdmi.phy_set = sunxi_dw_hdmi_phy_cfg; priv->mux = uc_plat->source_id;
+ ret = dw_hdmi_phy_wait_for_hpd(&priv->hdmi); + if (ret < 0) { + debug("hdmi can not get hpd signal\n"); + return -1; + } + uclass_get_device_by_phandle(UCLASS_I2C, dev, "ddc-i2c-bus", &priv->hdmi.ddc_bus);