Attempting to place device tree immediately after an image in memory can lead to mis-aligned data accesses if that image size is not divisible by the alignment requirements of the architecture.
Data aborts caused by this were observed on a custom Marvel A388 based system, where the image was a uboot FIT file. The total size varies depending on the uboot device tree size, which does not always lead to correct alignment.
Signed-off-by: Reuben Dowle reuben.dowle@4rf.com --- common/spl/spl_fit.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/common/spl/spl_fit.c b/common/spl/spl_fit.c index 365104f..d221075 100644 --- a/common/spl/spl_fit.c +++ b/common/spl/spl_fit.c @@ -349,9 +349,9 @@ static int spl_fit_append_fdt(struct spl_image_info *spl_image,
/* * Use the address following the image as target address for the - * device tree. + * device tree. Ensure that address is appropriately aligned. */ - image_info.load_addr = spl_image->load_addr + spl_image->size; + image_info.load_addr = ALIGN(spl_image->load_addr + spl_image->size, ARCH_DMA_MINALIGN);
/* Figure out which device tree the board wants to use */ node = spl_fit_get_image_node(fit, images, FIT_FDT_PROP, index++);