Newer Blackfin boot roms support using the fast SPI read command rather than just the slow one. If the functionality is available, then use it.
Signed-off-by: Mike Frysinger vapier@gentoo.org --- cpu/blackfin/initcode.c | 25 +++++++++++++++++-------- 1 files changed, 17 insertions(+), 8 deletions(-)
diff --git a/cpu/blackfin/initcode.c b/cpu/blackfin/initcode.c index a6e95f4..0fdaf40 100644 --- a/cpu/blackfin/initcode.c +++ b/cpu/blackfin/initcode.c @@ -133,12 +133,22 @@ static inline void serial_putc(char c) }
-/* Max SCLK can be 133MHz ... dividing that by 4 gives - * us a freq of 33MHz for SPI which should generally be +/* Max SCLK can be 133MHz ... dividing that by (2*4) gives + * us a freq of 16MHz for SPI which should generally be * slow enough for the slow reads the bootrom uses. */ +#if !defined(CONFIG_SPI_FLASH_SLOW_READ) && \ + ((defined(__ADSPBF52x__) && __SILICON_REVISION__ >= 2) || \ + (defined(__ADSPBF54x__) && __SILICON_REVISION__ >= 1)) +# define BOOTROM_SUPPORTS_SPI_FAST_READ 1 +#else +# define BOOTROM_SUPPORTS_SPI_FAST_READ 0 +#endif #ifndef CONFIG_SPI_BAUD_INITBLOCK -# define CONFIG_SPI_BAUD_INITBLOCK 4 +# define CONFIG_SPI_BAUD_INITBLOCK (BOOTROM_SUPPORTS_SPI_FAST_READ ? 2 : 4) +#endif +#ifdef SPI0_BAUD +# define bfin_write_SPI_BAUD bfin_write_SPI0_BAUD #endif
/* PLL_DIV defines */ @@ -254,12 +264,11 @@ void initcode(ADI_BOOT_DATA *bootstruct) * boot. Once we switch over to u-boot's SPI flash driver, we'll * increase the speed appropriately. */ - if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_SPI_MASTER) -#ifdef SPI0_BAUD - bfin_write_SPI0_BAUD(CONFIG_SPI_BAUD_INITBLOCK); -#else + if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_SPI_MASTER) { + if (BOOTROM_SUPPORTS_SPI_FAST_READ && CONFIG_SPI_BAUD_INITBLOCK < 4) + bootstruct->dFlags |= BFLAG_FASTREAD; bfin_write_SPI_BAUD(CONFIG_SPI_BAUD_INITBLOCK); -#endif + }
serial_putc('B');